Creative 3D Blaster Betriebsanweisung PDF herunterladen (Seite 13)

Product Guide 5

To install the

graphics card

1. Switch off your computer and all peripheral devices.

2. Disconnect the power cord from the wall outlet.

3. Touch any metallic surface on your computer to discharge any static electricity.

4. Remove the computer cover.

5. Locate a free AGP expansion slot.

Figure 2 shows the various types of expansion slots.

6. Remove the metal plate from the free expansion slot.

Keep the screw and metal plate for future use.

7. Align the bus connector of the graphics card with the

expansion slot.

8. Press the card’s bus connector gently and evenly into

the slot, making sure that the bus connector comes

into full contact with the slot. Then, secure the card

to the computer casing with a screw. See Figure 3 below.

9. Replace the computer cover and plug the power cord back into the wall outlet.

If you are replacing an existing

VGA card with 3D Blaster

Savage4, please remember to

remove the existing VGA card.

Figure 2: Types of expansion slots.

An AGP slot

A PCI slot

An ISA slot

Figure 3: Securing the graphics card to the slot.

ii. Secure the card to the

slot with a screw.

i. Gently and evenly press the card’s

bus connector into the slot.

Warning:

Do not force the

graphics card into place. If it does

not fit properly, gently remove it

and try again.

*Diagram shows Savage4 card

and AGP slot.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Keine Kommentare

Creative 3D Blaster Betriebsanweisung Seite 13